ruw stationair, motor valt uit
Geplaatst: di nov 12, 2019 3:41 pm
Hallo allemaal,
Zojuist zelf even de ECU uitgelezen met MES want mijn 1.6 draait stationair slecht, toerental rond de 850 maar zakt vaak daaronder en valt zelf uit, tevens bij indrukken koppeling (bijv. bij stoplicht).
Hieronder info wat ik er uit heb gehaald:
ECU ISO CODE 0D 07 98 01 02
FIAT Drawing NUmber 55187475
Hardware version 00
Software nummer 26616K331B
Software versie 0000
Homologatienummer 5NFT1
ECU programming date 09/06/2017 (is deze ecu van 2017 of dan geprogrammeerd? Ik weet dat er een nieuwe in is gekomen, op koele plaats/accu)
Errors:
P0460 - Fuel level sensor No signal | stored
P0340 - Phase Sensor Signal high | stored | light ON
P0340 zegt als omschrijving: The code is set when the Camshaft Position sensor signal is missing. Possible causes are:
- Connector or wire problem in the signal circuit (open or short to 12V or ground)
- Sensor installed improperly
Check the connectors, wiring and proper installation of the sensor, and the signal waveform with an oscilloscope.
PLEASE NOTE: Certain systems always set this fault code as long as the engine is not running (motor draaide wel!).
Ter aanvullende info: Onlangs is de kop eraf geweest, gevlakt ivm koplekkage. Nieuwe bougies, distri-set, waterpomp etc. Bobines gecheckt en middels andere bobines installeren gecheckt, leken goed.
Enig idee?
Dank!
Mike
Zojuist zelf even de ECU uitgelezen met MES want mijn 1.6 draait stationair slecht, toerental rond de 850 maar zakt vaak daaronder en valt zelf uit, tevens bij indrukken koppeling (bijv. bij stoplicht).
Hieronder info wat ik er uit heb gehaald:
ECU ISO CODE 0D 07 98 01 02
FIAT Drawing NUmber 55187475
Hardware version 00
Software nummer 26616K331B
Software versie 0000
Homologatienummer 5NFT1
ECU programming date 09/06/2017 (is deze ecu van 2017 of dan geprogrammeerd? Ik weet dat er een nieuwe in is gekomen, op koele plaats/accu)
Errors:
P0460 - Fuel level sensor No signal | stored
P0340 - Phase Sensor Signal high | stored | light ON
P0340 zegt als omschrijving: The code is set when the Camshaft Position sensor signal is missing. Possible causes are:
- Connector or wire problem in the signal circuit (open or short to 12V or ground)
- Sensor installed improperly
Check the connectors, wiring and proper installation of the sensor, and the signal waveform with an oscilloscope.
PLEASE NOTE: Certain systems always set this fault code as long as the engine is not running (motor draaide wel!).
Ter aanvullende info: Onlangs is de kop eraf geweest, gevlakt ivm koplekkage. Nieuwe bougies, distri-set, waterpomp etc. Bobines gecheckt en middels andere bobines installeren gecheckt, leken goed.
Enig idee?
Dank!
Mike